[Rule-list] Failed Miniconda Install

[Arthur Yarwood]

I've been trying to install Redhat 7.3 using your Miniconda installer
(version 0.7.4). However I'm getting this error when booting up the
installer:


running /sbin/loader
install exited abnormally -- received signal 11
sending termination signals...done
sending kill signals...done
disabling swap...
unmounting filesystems...
/proc done
/dev/pts done
you may safely reboot your system


This is the same error I was getting when I tried Redhat's own
installer. I'm guessed this was due to my lack of ram (only got 32Megs).
Although could Miniconda also be running out of ram? Or is this likely
to be some other conflict?

My system is an old ICL desktop, 486DX2 50Mhz, 32Meg fpm ram, Seagate
1gig HD, which splits itself in two to get around the 500meg ide limit.
ICL ethernet card; supported using the eth16i.o module on the drvnet.img
disk. I'll need to install across an nfs too. 

I have had stock Redhat 7.0 running ok on this machine. I was wanting to
update it though to run CUPS, which has nice drivers for my new laser
printer. I intend to use the machine as a print server you see. 

BTW you seem to have a lot of dead links on your website, notably the
all theones on the 'testers corner' page, like 'registering your computer'.

  Arthur Yarwood
-=[ fubaby.com ]=-


_______________________________________________
Rule Project HOME PAGE:  http://www.rule-project.org/rule/
Original Rule Development Site http://savannah.gnu.org/projects/rule/Rule-list at mail.freesoftware.fsf.org
http://mail.freesoftware.fsf.org/mailman/listinfo/rule-list